問一個多層式應用系統的問題 |
尚未結案
|
acnt
一般會員 發表:11 回覆:10 積分:4 註冊:2004-01-27 發送簡訊給我 |
|
terrychen
尊榮會員 發表:90 回覆:794 積分:501 註冊:2003-05-01 發送簡訊給我 |
|
acnt
一般會員 發表:11 回覆:10 積分:4 註冊:2004-01-27 發送簡訊給我 |
引言: 您好: 到project => options 你可以看到auto-create form下面第一ㄍFORM是您程式執行時會看到的,其他的若要看到則需下如:form2.show form3打不開是怎ㄇㄍ打不開法 ~~應無所住而生其心~~謝謝您的回答!!我已經把這問題解決了,form3可以叫出來,因為之前沒有把DCOM設定,但是現在又有一個問題,就是我要做DCOMConnection的Connected的社定要變為true,然後就當掉了,不知為啥為這樣,然後進度就一直停在這. |
joseph_liu
一般會員 發表:0 回覆:3 積分:0 註冊:2002-10-14 發送簡訊給我 |
hi, I haven't seen that book. I suggest you read the book carefully and do it again.
1. check you operation system, either you work on single computer or 2 computer(client and server).
2. make sure use "DCOMCNFG" to config the DCOM on the mechine(depends on where you install the DCOM server.
3. make sure the config in dcom "mechine..and the regist#." are correct.
4. if everythin done...then you can active the dcomconnection.. I don't have the software in current computer so I just write what I remember. I hope it will help. Joseph
|
Ktop_Robot
站務副站長 發表:0 回覆:3511 積分:0 註冊:2007-04-17 發送簡訊給我 |
本站聲明 |
1. 本論壇為無營利行為之開放平台,所有文章都是由網友自行張貼,如牽涉到法律糾紛一切與本站無關。 2. 假如網友發表之內容涉及侵權,而損及您的利益,請立即通知版主刪除。 3. 請勿批評中華民國元首及政府或批評各政黨,是藍是綠本站無權干涉,但這裡不是政治性論壇! |